Custom Parameters 3

This value defines the gas pressure to be purged at the end of program completion or abort of the program, to avoid the entering of foreign particles into the Cutting head.

This defines the 2^nd negative limit of Z axis, apart from the one defined in axis parameter. This value will be activated for the Upper Pallet if the Pallet has a 2 level of stages Upper/Lower level.

This defines the lag time to stop the dust collector after the completion of Program.

This defines the minimum distance between two gantries for Tandem Operation.

This defines the maximum stroke of X axis specifically for Tandem Operation.

This defines the maximum time limit for purging the assist gas at the end of program completion or abort of the program.

This defines the pressure value for purging the assist gas before start of the program.

This defines the time for purging assist gas before start of the program.

This is the Z-axis Park position value in mm, used in the Park Position program.

This defines the limit of X axis for nozzle cleaning, the limit may be either “Positive” or “Negative” depends on the availability of the space to fix the Nozzle clean brush.

For instance, there is a situation in the machine where the space to fix the Nozzle brush is only available in the negative direction of X-axis stroke but beyond the machine XY stroke limit, where the Y-axis cannot be travelled to full stroke.

Hence, only during Nozzle Cleaning Program the X-axis limit will be changed to this value to perform the Nozzle cleaning operation and once completed, will change back to Machine limit.